The top ten reasons that I see vehicles coming to Ace Automotive for no start problems
- Electric fuel pump failure /fuel filter restriction
- Timing Belt Failure / Timing belt tensioner failure
- Distributor Failure / Including Ignition control modules
- ECM/ PCM Failure (computer)
- Primarily on mid 80s GM products with 2.8L engines and “W” in the 8th position of the VIN #
- Crank / Cam Sensors
- Batteries/ Cables /Clamps
- Electrical Problems
One of the most common no-start problems I have seen in recent times is the failure of in-tank electric fuel pumps, primarily due to lack of proper scheduled maintain on the vehicle owners part of not having the fuel filter changed at the proper intervals, sure some fuel filters can cost approx. $100.00 and up to replace several times a year but in some vehicles such as late 90s Jeep Gran Cherokees replacing the fuel pump costs nearly $800.00! How many times do you want to pay that?
Also another cause for premature fuel pump failure is allowing the fuel level to get to below ¼ tank and below for extended periods or running completely out of fuel running out of fuel allows the electric fuel pump to run “dry” which nearly immediately ruins the pump.
Vortec Design GM engines 4.3L, 5.7L with the CPI fuel injection system the CPI unit fails in many different ways; the plastic tubes leak, the “poppets get plugged, the fuel pressure regulator leaks.
Timing belts are designed to last approx. 40,000-60,000 miles under normal use not changing the timing belt before it “breaks” can result in expensive engine damage in some vehicles, such as Honda, Acura, Nissan, and Mitsubishi. Always have the timing belt changed a little before the recommended change interval and check the tensioner replace if questionable. Timing belt tensioner failure is common.
Mid 80s Gm 4 cyl. V-6s
Most all GMs with Electronic distributor 4, cylinder, V-6, V-8 1988-1998)
80s / 90s Ford TFI ignition (grey module bolted to outside of distributor)
Ford Pick-up assemblies inside the distributor
I have seen many distributor failures on Hondas especially due to bearing failure.
Most problem alternator I have seen is the CS130 /CS130D on some mid 80s GMs for the CS130 and on later GMs the CS130D on like 92 and later makes like Gran Am, Gran Prix, etc.
Late model 92-93 Chrysler vehicles with 3.3L engine Caravan, Voyager,
Mid 80s GMs 2.0L crank sensors 2.5 L crank sensors
Mid 80s- early 90s GM V-6s crank sensors
90s Jeeps 4.0L engines cam/ crank sensors
Mitsubishi Galant 4 cyl engines crank sensors (failure due to balance belt failure and broken belt cuts sensor wires and damages sensor)
Many neglected corroded Batteries find their way to our facility; Batteries do not last forever! Poor Maintenance practices cause many many battery failures which often leads to other problems.
Ford ignition switches, in escorts in the early 90s the electrical portion of the ignition switch will separate inside, some ford ignition switches have been known to cause fires!
Vehicles out of fuel due to inaccurate fuel gauges
Engines locked up due to lack of oil
Plugged Exhaust systems (catalytic converters
Teeth missing or worn off the flywheel cannot turn the engine over
Bad fuel injectors
But I have NEVER seen or heard of a car not starting or running bad due to the brand of gasoline being used!
Owner, Technician Ace Automotive
11924 Pacific Hwy Sw.
Lakewood Wa, 98499